Ma andiamo con ordine la mia configurazione è la seguente
RB411AR + antenna omni direzionale da 5dbi + RouterOS 5.5
La RB la configurata con un rates massimo di uscita in 12mb cosi da permettere anche chi è più distante di avere un segnale qualitativamente migliore
La mia configurazione è la seguente
- Codice: Seleziona tutto
[admin@MikroTik] > interface wireless print advanced
Flags: X - disabled, R - running
0 R name="wlan1" mtu=1500 mac-address=00:0C:42:XX:XX:XX arp=enabled disable-running-check=no interface-type=Atheros AR5212 radio-name="000C42XXXXXX" mode=ap-bridge ssid="XXXXXXX" area=""
frequency-mode=regulatory-domain country=italy antenna-gain=5 frequency=2412 band=2ghz-onlyg channel-width=20mhz scan-list=default wireless-protocol=any rate-set=configured
supported-rates-b=1Mbps,2Mbps,5.5Mbps,11Mbps supported-rates-a/g=6Mbps,9Mbps,12Mbps basic-rates-b=5.5Mbps basic-rates-a/g=6Mbps max-station-count=2007 distance=dynamic
tx-power-mode=default noise-floor-threshold=default nv2-noise-floor-offset=default periodic-calibration=default periodic-calibration-interval=60 burst-time=disabled dfs-mode=none
antenna-mode=ant-a wds-mode=disabled wds-default-bridge=none wds-default-cost=100 wds-cost-range=50-150 wds-ignore-ssid=no update-stats-interval=disabled bridge-mode=enabled
default-authentication=yes default-forwarding=yes default-ap-tx-limit=0 default-client-tx-limit=0 proprietary-extensions=post-2.9.25 wmm-support=disabled hide-ssid=no
security-profile=default disconnect-timeout=3s on-fail-retry-time=100ms preamble-mode=both compression=no allow-sharedkey=no station-bridge-clone-mac=00:00:00:00:00:00
tdma-period-size=2 nv2-queue-count=2 nv2-qos=default nv2-cell-radius=30 nv2-security=disabled nv2-preshared-key="" hw-retries=7 frame-lifetime=0 adaptive-noise-immunity=none
hw-fragmentation-threshold=disabled hw-protection-mode=none hw-protection-threshold=0 frequency-offset=0 rate-selection=legacy
Secondo voi da cosa può dipendere questo problema?
