Problema due LAN

[ibm]

Chain prerouting

[nirinny]

ciao ibm, fatto ma ancora niente. Questa è regola:

chain=prerouting action=accept src-address-list=LOCAL
dst-address-list=LOCAL log=no log-prefix=""

[ibm]

Allora il problema è da un'altra parte

[ibm]

Prova a togliere la regola in ip route rules

[nirinny]

ciao ibm, disabilitando la regole in ip->route->rules funziona, ma la lan 10.0.9.0/24 esce con la wan della lan 10.0.72.0/24: ti allego lo screeshot dell'ip route attuale dove le due lan navigano con le rispettive wan

http://imagizer.imageshack.us/a/img911/1695/HJTdDG.png

e la rules di navigazione è attiva

[nirinny]

questo è il mangle configurato:

0 chain=prerouting action=accept src-address-list=LOCAL
dst-address-list=LOCAL log=no log-prefix=""

1 D chain=forward action=change-mss new-mss=1410 passthrough=yes tcp-flags=syn
protocol=tcp out-interface=all-ppp tcp-mss=1411-65535 log=no
log-prefix=""

2 D chain=forward action=change-mss new-mss=1360 passthrough=yes tcp-flags=syn
protocol=tcp in-interface=all-ppp tcp-mss=1361-65535 log=no log-prefix=""

3 chain=prerouting action=mark-connection new-connection-mark=wanconn
passthrough=yes in-interface=pppoe1 log=no log-prefix=""

4 chain=output action=mark-routing new-routing-mark=wan1 passthrough=yes
out-interface=ether2 connection-mark=wanconn log=no log-prefix=""

5 chain=prerouting action=mark-connection new-connection-mark=wan2conn
passthrough=yes in-interface=pppoe2 log=no log-prefix=""

6 chain=output action=mark-routing new-routing-mark=wan2 passthrough=yes
connection-mark=wan2conn log=no log-prefix=""

[nirinny]

ciao ibm hai altri consigli da darmi?